There are sport fishing applications where wire is also used as line and leader–Lake Trout in deep northern lakes comes to mind or saltwater fishing for Stripers and Bluefish–but for the most part, wire is for wire leaders. Breaking off the wire tag end this way will leave it smooth. Regardless of weight, all wire is stiffer than the stiffest monofilament or fluorocarbon leader. With my wire lines I make a loop in the end and pass this through the swivel eye and then the swivel through the loop to form a slip knot on the eye. Then the guidance on location, timing, when to try something different, or when to move on can be all that more effective. First, it can only be used with single-strand wire (it doesn’t work for multi-strand wire, as it has to be crimped). But fish don’t need teeth to make wire suitable, and there are plenty of old timers who have always used wire for night Tarpon fishing. Crimping with the right size crimps, wire and crimping tool is critical. Seams to me this is the weakest of the 3 because the wire would cut the leader on a big fish like a king, probably doesn’t really matter with Spanish. The next step is to bend the tag end at a 90-degree angle to the standing part of the wire and begin to make four to six barrel wraps tight to each other.For Kingfish, we tend to use 4-weight wire, which measures in at 38lb test. I’ll give the knots a few practice trials.Here’s what you’ll receive today when you join:2. Basically speaking if you are fishing terminal fish–open water predators or bottom feeders with teeth (the sharks)–be ready to use wire.Before we move forward, we should make a comment about pre-tied wire leaders. You can usually tie your braided line to the barrel swivel and clip the lure or hook onto the other end, which contains a snap. The lower the stated weight, the thinner and lighter and, to some extent, the more flexible the wire. Here are four ways to tie a swivel. Although they are often mocked by guides and high end amateurs (all you elitists know who you are), they do work. Please let me know your thoughts.Save 30% And Put An End To Your Monthly Charges.In case you missed it, the finished product also includes a Haywire Twist to connect the wire leader to the hook or jig head.In December of 2014, these two brothers shocked their clients, friends, and family by quitting their 6-figure jobs to start their dream focused on helping saltwater anglers:Do what the “SMART ANGLERS” are doing and join the Insider Club.Check out the video below to learn how to tie a Haywire Twist.Use the Albright Special to tie your wire leader directly to your mono or fluorocarbon leader.If you’re targeting toothy fish like mackerel, sharks or barracuda, you’re going to need a wire leader.Thanks. Thank you for watching.. ... PE Line Without Leader And Snap ! Sure, you could use a swivel to connect your mono or fluorocarbon leader to the wire leader, but that extra hardware might tip off the fish that there’s something not quite right, and result in fewer strikes… Otherwise your crimp can either damage the multi-strand wire because it was crimped too tight, thus weakening the wire, or crimped too loose, thus running the risk of the connection pulling apart when you hook a big fish.Wire leader comes into play when you’re fishing for fish with teeth sharp enough to cut through regular monofilament or fluorocarbon leader; for instance, Mackerel and Bluefish. It’s knot time! You also need a crimping tool that has the right size millimeter gap as the crimps you’re using. They are effective for immediate rigging and when you are using spoons and other lures for very active open water predators. After you make the loop through your hook, lure, or terminal tackle, you’re not wrapping one wire around the other, but twisting them together.